heater hoses (inside)
-
- Senior Member
- Posts: 100
- Joined: Thu Dec 13, 2007 8:52 am
heater hoses (inside)
are there any schematic drawings/photos of how the heater tubes are hooked up from the heater channels up to the dash corners and from there to the center of the dash??
- jmartini
- Administrator
- Posts: 1316
- Joined: Fri Dec 23, 2005 8:43 pm
- Location: Nevada, Texas
- Contact:
Hi Bill: I sent you an email but just in case you don't get it here's the recap on the pictures. First let me say that this is a really hard place to get a camera. As you will see in the photo the "Y" connector is down in the tunnel (this shot is the left side - below the glove box).
Photo 15 - looking down at the connector in the tunnel
Photo 7 - both tubes coming up from the tunnel - the one next to the glove box routes over the glove box and onto the center defroster. The tube coming up on the outside (to the left of the hinge) routes to the side vent.
Photo 13 - A bonus shot of the "Y" connector.
I did not resize the images because the detail would probably be too small to see, there fore you need to click on the "Download" link.
Hope this helps!
Photo 15 - looking down at the connector in the tunnel
Photo 7 - both tubes coming up from the tunnel - the one next to the glove box routes over the glove box and onto the center defroster. The tube coming up on the outside (to the left of the hinge) routes to the side vent.
Photo 13 - A bonus shot of the "Y" connector.
I did not resize the images because the detail would probably be too small to see, there fore you need to click on the "Download" link.
Hope this helps!
- Attachments
-
- Image013.jpg
- (834.94 KiB) Downloaded 681 times
-
- Image007.jpg
- (954 KiB) Downloaded 712 times
-
- Image015.jpg
- Photo 15
- (801.09 KiB) Downloaded 711 times